Knife over roller
A knife is set at a fixed gap above a roller. The amount of chemical that goes onto the fabric depends on the gap, the viscosity of the paste, the angle and profile of the knife, and the line speed.
Knife over air
The knife sits over unsupported fabric, which is held by rollers on either side of the knife or by a table. Add-on depends on fabric tension, paste viscosity, the knife's angle and profile, and line speed.
Reverse roll
A roller turning against the direction of the fabric applies chemical to its surface.
Foam coating
Similar to knife over roller, with a foam in place of a paste. We use it mainly on open or stretch fabrics. The chemical sits on top of the fabric with very little penetration, so the result usually has a softer handle than a paste coat. Foam-coated fabric is generally air permeable, which suits filtration products but not waterproofing.
Hot melt
Hot melt is applied directly to the fabric surface. Its main use is stiffeners for the footwear industry.